StarTech.com USB3S2SAT3CB Bedienerhandbuch PDF herunterladen (Seite 6)

Instruction Manual

Installation

Hardware Installation

WARNING! Hard drives and storage enclosures require careful handling, especially

when being transported. If you are not careful with your hard disk, lost data may

result. Always handle your hard drive and storage device with caution. Be sure that

you are properly grounded by wearing an anti-static strap when handling computer

components or discharge yourself of any static electricity build-up by touching a large

grounded metal surface (such as the computer case) for several seconds.

Note: This adapter cable will only work with 2.5” hard drives, and solid state drives. 3.5”

Hard drives and optical drives require a high power load than can be provided via the

USB bus.

1. Connect the SATA Connector to the SATA reciprocal on your 2.5” SATA hard drive/

solid state drive.

2. Connect the USB connector from the cable to a USB port on the host computer

system (optimal perfomance with USB 3.0, backward compatibile with USB 2.0/1.1).

Operation

Connecting the Hard Drive

Once the cable has been attached to a computer, and the necessary software will

automatically install, and the drive will be accessible as though it were installed within

the system.

Prior to using the drive, it will need to be formatted according to your operating

system requirements. To format your newly attached hard drive, or create partitions,

please consult the documentation that accompanied your operating system at the

time of purchase.

Powering the Drive

The hard drive adapter requires no external power supply, as it is capable of receiving

enough power from the USB Bus to which it is connected

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

StarTech.com USB3S2SAT3CB Bedienerhandbuch Seite 6