StarTech.com PEX1000SFP2 Bedienerhandbuch PDF herunterladen (Seite 11)

Instruction Manual

1. Install your desired SFP into the SFP slot on the card.

2. Prepare a network cable with corresponding connectors for the two end devices.

One end to the PCI Express Fiber Gigabit Ethernet Adapter and the other to a

1000Mbps ber port on the network switch.

3. Connect the network cable to the connector on the PCI Express Fiber Gigabit

Ethernet Adapter. This network cable consists of two individual cables: one for

“transmission (TX)”, and the other for “reception (RX)”.

4. Connect the other end of the network cable to a 1000BASE-SX/LX switch.

5. i. Insert the cable that is connected to the transmit (TX) connector on the PCI

Express Fiber Gigabit Ethernet Adapter into the receive (RX) connector on the

network switch.

ii. Insert the cable that is connected to the receive (RX) connector on the PCI Express

Fiber Gigabit Ethernet Adapter into the transmit (TX) connector on the network

switch

6. When the cable is properly connected to two end devices, turn on the power to the

PC.

7. Check the LNK (Link) LED. The LED will come on when the PCI Express Fiber Gigabit

Ethernet Adapter is receiving a good link signal from the connected device, or

switch.

Card to Card Direct Conguration

The PCI Express Fiber Gigabit Ethernet Adapter allows for a card-to-card direct ber

connection. One adapter should be set to “auto negotiation mode” while the other

should be set to “1000 Mbps full duplex mode” when two card adapters are connected

to each other via ber connectors.

Follow the below jumper settings to create a direct conguration:

1. Auto negotiation (default setting): Set the JP2 jumper conguration for “Card A”

to jumper position “2 and 3.”

2. 1000Mbps full duplex: Set the JP2 jumper conguration for “Card B” to jumper

position “1 and 2.”

1 2 ... 6 7 8 9 10 11 12 13 14 15

Keine Kommentare

StarTech.com PEX1000SFP2 Bedienerhandbuch Seite 11